Special Issue
  • Interlaminar Shear and Joint Strength Evaluation of C/SiC Composites for Application to Regeneratively Cooled Scramjet Combustors

  • Ji Beom Choi*, Soo-Hyun Kim*† , Seyoung Kim*, In-Sub Han*, Hyung-Joon Bang*, Young-Hoon Seong*, Seulhee Lee*

  • * High Temperature Energy Conversion Laboratory, Korea Institute of Energy Research

  • 스크램제트 엔진 재생냉각 연소기 적용을 위한 C/SiC 복합소재의 층간전단 및 접합부 강도 평가

  • 최지범* · 김수현*† · 김세영* · 한인섭* · 방형준* · 성영훈* · 이슬희*

  • This article is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/4.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.

References
  • 1. Upadhya, K., Yang, J.M., and Hoffman, W.P., “Advanced Materials for Ultrahigh Temperature Structural Applications Above 2000oC,” American Ceramic Society Bulletin, Vol. 76, No. 12, 1997, pp. 51-56.
  •  
  • 2. Lee, S., Kim, S.H., Kim, S., Choi, J., and Choi, H.J., “Hoop Tensile Strength of Tubular Carbon Fiber Reinforced Silicon Carbide Matrix Composites,” Ceramics International, Vol. 44, No. 14, 2018, pp. 17087-17093.
  •  
  • 3. Shim, G., Kim, S.H., Kim, S., Han, I.S., Bang, H.J., Seong, Y.H., Lee, S., Kim, W.S., and Shin, K., “Influence of Pyrolysis and Melt Infiltration Temperatures on the Mechanical Properties of SiCf/SiC Composites,” Ceramics International, Vol. 48, No. 2, 2022, pp. 1532-1541.
  •  
  • 4. Choi, J.B., Kim, S.H., Lee, S., Han, I.S., Bang, H.J., Kim, S. and Seong, Y.H., “Effect of Fiber Dispersion on Mechanical Strength of SiCf/SiC Composites,” Composites Research, Vol. 36, No. 3, 2023, pp. 180-185.
  •  
  • 5. Bakos, R., “Current Hypersonic Research in the USA,” Adv Propul Technol High-Speed Aircr, Vol. 10, pp. 1-26, 2008.
  •  
  • 6. Erbland, P.J., “Current and Near-term RLV/Hypersonic Vehicle Programs,” RTO/AVT VKI Lecture Series on “Critical Technologies for Hypersonic Vehicle Development, Brussels, Belgium, 10-14. 2004.
  •  
  • 7. Kim, S.H., Kim, S., Seong, Y.H., Han, I.S., and Bang, H.J., “Structural Design and Pressure Test for CMC Regenerative Cooled Hypersonic Combustor,” Proceedings of the 2019 Spring Conference of the Korean Society of Propulsion Engineers, Jeju, Republic of Korea, 2019.
  •  
  • 8. Hu, W., Huang, J., Zhang, C., Ren, T., Guan, T., Wu, K., ... and Suo, T., “Effect of Shear Strain Rate on Interlaminar Shear Behavior of 2D-C/SiC Composites: A Damage Transition from Notch Ends Initiation to Gauge Section Initiation,” Carbon, Vol. 167, 2020, pp. 770-784.
  •  
  • 9. Wang, H. L., Zhang, C.Y., Liu, Y. S., Han, D., Li, M., and Qiao, S.R., “Temperature Dependency of Interlaminar Shear Strength of 2D-C/SiC Composite,” Materials & Design (1980-2015), Vol. 36, 2012, pp. 172-176.
  •  
  • 10. Zhang, C., Wang, H., Liu, Y., Qiao, S., Li, M., and Han, D., “Interlaminar Shear Damage Mechanisms of a 2D-C/SiC Composite at Elevated Temperature in Vacuum,” Vacuum, Vol. 105, 2014, pp. 63-68.
  •  
  • 11. Schulte‐Fischedick, J., Frieß, M., Krenkel, W., and Thielicke, B., “The Interlaminar Shear Strength of C/C‐SiC,” High Temperature Ceramic Matrix Composites, 2001, pp. 181-186.
  •  
  • 12. He, Z., Zhang, L., Chen, B., Zhang, J., Liu, Y., and Liu, X., “Microstructure and Mechanical Properties of SiC Bonded Joints Prepared by CVI,” International Journal of Adhesion and Adhesives, Vol. 64, 2016, pp. 15-22.
  •  
  • 13. Rizzo, S., Grasso, S., Salvo, M., Casalegno, V., Reece, M.J., and Ferraris, M., “Joining of C/SiC Composites by Spark Plasma Sintering Technique,” Journal of the European Ceramic Society, Vol. 34, No. 4, 2014, pp. 903-913.
  •  

This Article

Correspondence to

  • Soo-Hyun Kim

  • High Temperature Energy Conversion Laboratory, Korea Institute of Energy Research

  • E-mail: kishing@kier.re.kr