Original Article
  • 테이프 캐스팅 공정으로 제조된 BaMoO4 세라믹 유전체의 주파수 의존 유전 특성에 미치는 하소 및 소결 온도의 영향

  • Jihye Seo*, **, Moonhee Choi**† , Yoonmook Kang*†

  • * Graduate School of Energy and Environment, Korea University, Seoul 02841, Korea
    ** Research & Innovation Division, Korea Institute of Ceramic Engineering & Technology, Jinju 52851, Korea

  • Effects of Calcination and Sintering Temperatures on the Frequency-Dependent Dielectric Properties of Tape-Cast BaMoO4 Ceramic Dielectrics

  • 서지혜*, ** · 최문희**† · 강윤묵*†

  • This article is an open access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/by-nc/4.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.

References
  • 1. McGarry, M.P., and Lee, M., “Broadband dielectric properties of integrated circuit packaging materials across the 6G spectrum,” IEEE Transactions on Components, Packaging and Manufacturing Technology, Vol. 12, No. 9, 2022, pp. 1575-1582.
  •  
  • 2. Narang, S.B., and Bahel, S., “Low loss dielectric ceramics for microwave applications: a review,” J. Ceram. Process. Res, Vol. 11, No. 3, 2010, pp. 316-321.
  •  
  • 3. Hung, C.-M., Ho, Y.-C., and Wu, I.-C., “High-Q capacitors implemented in a CMOS process for low-power wireless applications,” IEEE Transactions on Microwave Theory and Techniques, Vol. 46, No. 5, 1998, pp. 505-511.
  •  
  • 4. Al-Keisy, A.H.J., P-block-based Ferroelectric-photocatalyst Compounds: Structure, Ferroelectric Properties and Photocatalytic Performance, Ph.D. Thesis, University of Wollongong, Wollongong, Australia, 2018.
  •  
  • 5. Ren, P., Zhao, H., Wang, X., Wan, Y., Liu, Z., Long, C., Yan, F., Frömling, T., and Zhao, G., “Super-stable permittivity and low dielectric loss of (1-x) Na0.5Bi0.5+yTiO3-xNaTaO3 ceramics within an ultra-wide temperature range,” Journal of Materiomics, Vol. 9, No. 3, 2023, pp. 482-491.
  •  
  • 6. Zhou, J., “Towards rational design of low-temperature co-fired ceramic (LTCC) materials,” Journal of Advanced Ceramics, Vol. 1, No. 2, 2012, pp. 89-99.
  •  
  • 7. Mazlan, M.R., Jamadon, N.H., Rajabi, A., Sulong, A.B., Mohamed, I.F., Yusof, F., and Jamal, N.A., “Necking mechanism under various sintering process parameters–A review,” Journal of Materials Research and Technology, Vol. 23, 2023, pp. 2189-2201.
  •  
  • 8. e Silva, R.L.S., and Franco, A., “Effect of porosity on dielectric properties of ZnO ceramics,” Journal of the European Ceramic Society, Vol. 40, No. 4, 2020, pp. 1307-1311.
  •  
  • 9. Kingery, W.D., Bowen, H.K., and Uhlmann, DR., Introduction to Ceramics. John Wiley & Sons, 1976.
  •  
  • 10. Nelson, S.O., “Density-permittivity relationships for powdered and granular materials,” IEEE Transactions on Instrumentation and Measurement, Vol. 54, No. 5, 2005, pp. 2033-2040.
  •  
  • 11. Ghosh, S.K., Rout, S.K., Tiwari, A., Yadav, P., Sczancoski, J.C., Filho, M.G.R., and Cavalcante, L.S., “Structural refinement, Raman spectroscopy, optical and electrical properties of (Ba1−xSrx) MoO4 ceramics,” Journal of Materials Science: Materials in Electronics, Vol. 26, No. 11, 2015, pp. 8319-8335.
  •  

This Article

Correspondence to

  • Moonhee Choi ** , Yoonmook Kang *

  • * Graduate School of Energy and Environment, Korea University, Seoul 02841, Korea
    ** Research & Innovation Division, Korea Institute of Ceramic Engineering & Technology, Jinju 52851, Korea

  • E-mail: moonhee77.choi@kicet.re.kr (Moonhee Choi); ddang@k